How to measure your shutter
Measuring correctly avoids delays and remanufacturing costs. Follow the procedure that matches your situation and, if in doubt, send us photographs of the opening — we will check with you before producing anything.
Before you start
- Use a steel tape measure, never a fabric one.
- Always measure in millimetres and write every value down.
- Measure each opening individually, even if they look identical.
- Check the opening is square: measure both diagonals as well.

Surface-mounted shutter (applied box)
- Width of the opening
Measure the width at three points — top, middle and bottom — and give us all three values. We manufacture with the required technical clearance.
- Height of the opening
From the highest point of the opening to the sill or the finished floor, again at three points (left, centre, right).
- Space above the opening
The clear height available above the opening for the box. This dimension sets the maximum box size, and therefore the maximum shutter height.
- Available depth
Clear depth on the external wall, particularly if there is an eave, a pillar or a balcony nearby.
Replacement in an existing box (RKS)
- Internal width of the box
Measure the clear width inside the box, from cheek to cheek, excluding the side covers.
- Box height and depth
These two dimensions determine the maximum roll diameter, and therefore how much shutter height will fit.
- Height to cover
From the bottom of the box to the sill or the floor — this is the working height of the curtain.
- Existing guides
Tell us whether you want to reuse the side guides or replace them. Photograph them, including the top entry.
Shutter for a construction box, or monobloc
- Internal box dimensions
Internal width, height and depth of the built-in box, plus the position of the cable outlets provided.
- Width between guides
If the guides are already fitted, measure the distance between the backs of the two channels.
- Total height to cover
From the tube axis to the desired bottom stopping point.
Illustrated guides and installation PDFs
The full guides from the main site, with diagrams and photos. Insect screens come with an installation PDF to print or open on your phone.
Measuring guides
- Measuring a surface-mounted or frame-fitted roller shutter
- Measuring a monobloc shutter
- Measuring an insect screen
Install an insect screen
- ENROLA Easy Fit (roller) — Online guide · PDF
- PLISSA mini (pleated) — Online guide · PDF
- CORRE (sliding) — Online guide · PDF
- PRACTIK (door) — Online guide · PDF
- FIXE (fixed) — Online guide · PDF
Prices
One photo of the opening from outside, one from inside and one close-up of the existing box or guide will answer nearly every question. You can attach them directly to your quote request.
For supply without installation, the dimensions given in the quote are the customer's responsibility: a made-to-measure shutter cannot be exchanged because of a measuring error. In the districts of Aveiro and Porto we can come and measure — and in that case the responsibility is ours.