How to install the PRACTIK door insect screen
The PRACTIK door screen is a hinged leaf on pin hinges. Lift the leaf off first, fix the frame in the opening — properly levelled — then hang the leaf back.
In short The PRACTIK door insect screen goes in in a few steps, with a drill, spirit level and screwdriver. This illustrated guide gives the steps, final checks and a PDF with QR code to print or open on your phone.
Before you start
Tools
- Drill with bits suited to the wall or frame
- Spirit level (or laser)
- Tape measure and pencil
- Screwdriver
People
2 people (the leaf is about 2 m tall)
Step by step
1. Lift off the leaf
Lift the leaf to free it from the hinge pins, top and bottom.

2. Separate frame and leaf
Set the leaf aside somewhere safe and take only the frame to the opening.

3. Level and fix the frame
Centre the frame in the opening, check plumb and level of the rails and fix it with the drill at the provided points.

4. Hang the leaf back
Offer the leaf up to the hinge pins and let it drop, top and bottom, until it seats.

5. Check the closing
Open and close several times: the leaf should close evenly all round. With the optional self-closing hinge, check it closes by itself.

Final checks
- The leaf opens the ordered way and closes without rubbing.
- The gap is even all round.
- The frame screws are tight.
Need a hand?
If something does not fit, do not force it: photograph the problem and send it to us. You can also read the measuring guide or the range page.
Measuring guide Range page: PRACTIK Contact us
Illustrations based on the profile manufacturer’s assembly instructions.
Frequently asked questions
Does the door screen close by itself?
Only with the optional spring-return hinge. Without it the leaf stays where you leave it.
Can I change the opening side after fitting?
The opening side (right or left) is set when ordering. To reverse it, contact us before drilling.