How to install the CORRE sliding insect screen
The CORRE sliding screen arrives assembled: nothing to join. It goes into the sliding window frame — top first, then the bottom — and is adjusted to glide freely.
In short The CORRE sliding insect screen goes in in a few steps, with a drill, spirit level and screwdriver. This illustrated guide gives the steps, final checks and a PDF with QR code to print or open on your phone.
Before you start
Tools
- Drill with bits suited to the wall or frame
- Spirit level (or laser)
- Tape measure and pencil
- Screwdriver
People
1 person; 2 if the leaf is large
Step by step
1. Place the screen in the frame
Tilt the screen, push the top into the upper track, then drop the bottom into the lower track. The spring top squares adapt to the frame.

2. Check and adjust
Slide the leaf from end to end: it should roll smoothly. If it rubs or wobbles, adjust the wheels in the bottom squares with a screwdriver until it is plumb.

Final checks
- The leaf glides without force both ways.
- No visible gap at top or bottom.
- The window opens and closes without touching the screen.
Need a hand?
If something does not fit, do not force it: photograph the problem and send it to us. You can also read the measuring guide or the range page.
Measuring guide Range page: CORRE Contact us
Illustrations based on the profile manufacturer’s assembly instructions.
Frequently asked questions
Does the sliding screen fit any frame?
It fits most aluminium frames thanks to the adjustable squares. If unsure, send us photos of the top and bottom of the window.
How do I take it out to clean it?
Do the same in reverse: lift the leaf to free the bottom, then take it out from the top.