Installation guide

How to install the ENROLA Easy Fit roller insect screen

The ENROLA Easy Fit roller screen goes up in five moves: prepare the foot of the guides, seat the box in the opening, slide in the guides, fix them and test. The spring cap plates hold the box while you work and absorb small measuring errors.

In short The ENROLA Easy Fit roller insect screen goes in in a few steps, with a drill, spirit level and screwdriver. This illustrated guide gives the steps, final checks and a PDF with QR code to print or open on your phone.

Before you start

Tools

  • Drill with bits suited to the wall or frame
  • Spirit level (or laser)
  • Tape measure and pencil
  • Screwdriver

People

1 person for most openings; 2 people above 1.5 m wide

What is in the box

In the box: the cassette with the screen, two guides, the guide feet (hidden or adjustable closure) and two end caps.

In the box: the cassette with the screen, two guides, the guide feet (hidden or adjustable closure) and two end caps.

Step by step

  1. 1. Prepare the foot of the guides

    Depending on the closure: hidden, the foot slides into the guide; adjustable, you clip in the hinged foot that lets you fine-tune the guide at the end. Do the same on both guides.

    1. Prepare the foot of the guides
  2. 2. Seat the box in the opening

    Tilt the box, compress the spring cap plates at each end and push it up against the lintel (or the top of the opening). The spring holds it in place and absorbs small irregularities.

    2. Seat the box in the opening
  3. 3. Slide in the guides

    Engage the top of each guide in the end of the box, then swing the bottom into the opening. Repeat on the other side; the spring keeps the box held.

    3. Slide in the guides
  4. 4. Level and fix the guides

    Check plumb with the level, then drill and screw each guide at the marked points (four fixings per side, as shown). With the adjustable closure, tune the foot at the bottom until the guide is perfectly vertical.

    4. Level and fix the guides
  5. 5. Test it

    Pull the end bar down by its handle, then let it retract: the mesh should glide without rubbing. If it binds, slacken the guides slightly and realign them.

    5. Test it

Final checks

  • The mesh runs down and up without rubbing in the guides.
  • Both guides are plumb and equally spaced from the box.
  • The end bar closes snugly against the sill.

Need a hand?

If something does not fit, do not force it: photograph the problem and send it to us. You can also read the measuring guide or the range page.

Measuring guide Range page: ENROLA Easy Fit Contact us

Illustrations based on the profile manufacturer’s assembly instructions.

Frequently asked questions

Can I fit the roller screen myself?

Yes, in most openings. Above 1.5 m wide a second person helps hold the box while you slide in the guides.

What if the guide rubs the mesh?

Check plumb and, with the adjustable closure, adjust the guide foot. If it persists the opening may be out of square: send us photos.

Ready to order, or would you rather have a quote?

In the shop, enter your sizes and see the price at once. For a larger project, with installation or several pieces, send us your sizes: we reply within 24 to 48 working hours with a detailed, no-obligation quote.

WhatsApp