Tubular motor being fitted into a shutter's winding tube

Motorise an existing manual roller shutter

If your shutter's curtain and guides are still in good condition, there is no reason to replace everything. We swap the axle for an A-OK motorised tube and the shutter goes up and down at the touch of a switch — with no wall chasing and no visible cable.

In short You can motorise a manual shutter without replacing it: we swap the shaft for a tube with an A-OK AM45 radio motor and supply a magnetic wall switch you stick wherever you like. There is no chasing or cabling, and in most cases the job is finished the same morning. The curtain and guides must be in good condition.

A routine job, not an exception

The strap mechanism is the first thing to fail on a shutter: the strap snaps, the winder pulls out of the wall, the crank bends. The aluminium curtain, on the other hand, lasts for decades. Rather than throwing out a shutter that still works, we open the box, take out the old axle and mechanism and fit an octagonal tube with an A-OK AM45 radio motor inside.

Because the motor is radio-controlled, the switch does not need to be wired to anything: it is a magnetic wall switch that sticks wherever you want it, including straight over the old strap opening. No chasing, no cable runs, no building work. In most cases the job is done in a morning.

What you get out of it

  • The existing curtain, guides and box are kept — only the worn parts are replaced
  • Magnetic wall switch included, stuck wherever suits you, no drilling and no cable
  • The strap opening is filled and the winder disappears from the wall
  • You can add a handheld remote, a timer or solar power later without reopening the box

Request a quote

Tubo octogonal com motor tubular A-OK
The same motor as on our new shutters
Interruptor de parede magnético
Magnetic wall switch — Standard

How it works

  1. Photo and sizes

    Send us the opening width, the curtain height and a photo of the inside of the box with the axle visible. If you cannot open the box, we will tell you how.

  2. Firm quote

    We confirm feasibility and price within 24 to 48 working hours, motor, tube, brackets and switch included.

  3. Axle replacement

    In Aveiro and Porto we come to you. Outside those areas we ship the assembly ready to fit, with the motor already programmed.

  4. Testing and end limits

    We set the upper and lower limits, pair the switch and leave the shutter working.

Three things to check first

The curtain runs freely

If it grinds, bows or scrapes in the guides, the mechanism is not the problem. Replacing the whole shutter may then make more sense — and we will say so.

The box opens

We need access to the axle, from inside or from below. A fully sealed masonry box means cutting an inspection hatch.

There is room for the tube

A motorised octagonal tube needs a few centimetres more than a plain axle. We check that against your photo and box dimensions.

Standard

The same motor as on our new shutters

We use exactly the same 868.3 MHz A-OK AM45 radio motor we fit to factory-built shutters: no hub, no compulsory app and no subscription. If you motorise more windows later, they all answer the same handheld remote.

A-OK Motors

ModelA-OK AM45 (AM45C series, built-in radio)
Power supply230 V AC · 50/60 Hz
Power280 W · 1.22 A
Torque50 N·m
Speed12 rpm
Radio frequency868.3 MHz (FSK modulation)
Protection ratingIP44
Operating temperature−20 °C to +65 °C
DutyS2 4 min
And if the shutter is not worth keeping?

It happens, and we say so. When the curtain is broken or the guides are bent, a new surface-mounted shutter costs barely more than the conversion and gives a far better result. We send both quotes side by side and you decide.

Surface-mounted shutters

Motorising an existing shutter

To price it we need the opening sizes (previous step) and, if possible, a photo of the inside of the box with the axle visible — you can attach it at the last step. Also tell us the current mechanism (strap, cord or crank) in the final message. The box shape, colour and density below do not apply: the existing curtain and guides are kept.

Request a quote

Frequently asked questions

Do walls need to be opened or cables run?

No. Because the motor is radio-controlled, the wall switch is magnetic and sticks wherever you like, including over the old strap hole. No chasing, no cables, no building work.

What should I include in the quote request?

The dimensions of the shutter box, the width of the opening and the current operating type: strap, crank or belt.

Which motor is installed and what is included?

The A-OK AM45 tubular motor with built-in radio receiver. The magnetic wall switch is included in the price, and we programme the travel limits.

Ready to order, or would you rather have a quote?

In the shop, enter your sizes and see the price at once. For a larger project, with installation or several pieces, send us your sizes: we reply within 24 to 48 working hours with a detailed, no-obligation quote.

WhatsApp